Too much UV light will decompose the resin. It is also much easier to grind away the attachement points of the support structure. The heat will open the pores of your skin and the resin can enter your body more easily.Īfter curing it is save to touch the resin. Dont use alcohol to clean your skin as the alcohol makes you skin dry and the resin can enter your body more easy.
If you touched the liquid resin wash the area with cold/mild water and soap for 10-15 minutes. If there is any part of uncured resin whipe it away with a piece of cloth or paper and cure that piece in UV light. Avoid skin contact and do not inhale the gases (for example if it burns, for whatever reason).
As long as the resin is not fully cured it is still toxic. 10 minutes at 40☌ are enough to damadge the model. It is recommended to remove the support structure (starting from the top of the miniature) with a shart pointy side cutter ( Tamiya side cutter)Īfter that you must put the models in UV light for half an hour (sunlight also works but might take longer depending on the UV intensity of your location) to fully cure.ĭo not heat the models. They are pre-cured and must be fully cured by the customer. This means no warping of parts, no seam lines and very fine details. The models are 3d printed with an high quality printer. If you begin experiencing any adverse reactions while sanding polyurethane resin, you should contact a physician immediately. The room in which you are working should be well-ventilated. Gloves and a long-sleeved shirt are also a good idea to reduce skin exposure. When sanding polyurethane resin, use wet sandpaper to reduce the amount of airborne dust, and always wear a filter mask and safety goggles. Risk of inhalation can be mitigated by taking certain precautions. On combustion, may emit toxic fumes of carbon monoxide (CO). Accidental ingestion may cause illness or irritation to the mouth and gastrointestinal tract.Īvoid generating dust fine dust dispersed in air in sufficient concentrations and in the presence of an ignition source is a potential dust explosion hazed. Dusts may cause temporary mechanical irritation to the eyes, skin, and respiratory tract. Use a respirator when grinding, sanding or sawing resin.
0 kommentar(er)
